logo
Navigation Menu
Menu
Home > News > What if the ore crusher is not easy to boot in winter

Contact Us

What if the ore crusher is not easy to boot in winter

(Rating: 4.00 / 5 - total 1 votes)
Loading...
Date: 2018-12-17


When the crusher is used in winter, because the climate is cold, the diesel engine is difficult to start, the cooling water and the electrolyte are easy to freeze, and the wear and fuel consumption of the parts are significantly increased. Therefore, the ore crusher will have an ore crusher in the case of relatively low temperature in winter. In the difficult situation of starting, Shanghai Joyal Mining Machinery reminds the users to pay attention to the maintenance of the ore crusher before the winter, which can reduce the problem that the ore crusher does not start well in winter.

Users should pay attention to the timing of cleaning the ore crusher equipment, the appearance of the diesel engine, the chassis and the working device can play the role of descaling and decontamination. In the cleaning process, the damage of each device and components and the leakage of oil can be found for the next step. Maintenance and doing the preliminary work. It is strictly forbidden to use high-pressure and high-temperature water guns to rinse the parts with high waterproof requirements, especially the electrical parts, so as not to cause damage.

Diesel is easy to wax at low temperature, viscosity increases, fluidity deteriorates, poor atomization, which deteriorates the combustion process, causing the diesel engine of the ore crusher to fail to operate normally. In order to soften the diesel engine and reduce fuel consumption, the condensation point should be selected. Low diesel. The general selection principle is: the condensation point of diesel is about 5 °C lower than the environmental mixing. The diesel grades available for winter are: -10#, -20#, -35#, etc.

Users also need to pay attention to the maintenance of the ore crusher when it is hungry, the fuel system should be cleaned. Thoroughly clean all the filter screens, replace the fuel filter, discharge the sewage from the oil-water separator and clean it. At the same time, carefully check the working condition of the oil pump of the ore crusher to eliminate the hidden troubles.



©2024 Shanghai Joyal Machinery Co., Ltd. All rights reserved.              E-Mail:joyal@crusherinc.com